PDA

View Full Version : Pan + Volume reset when in GPO4 when midi playback begins



Gamma
11-13-2011, 10:02 PM
Hello all,

I'm new to GPO4 and I'm facing a little beginner's problem here... I've done a few tests to sort it out and this is where I stand:

1) I create a new instrument channel in my DAW (n-track) and assign it to the Aria Player VST.
2) I create a small ensemble of three instruments.
3) I set the volumes, pans, effect sends, etc... and save+close the song right there. No tracks created. When I reopen the song and access the Aria Player, my ensemble shows up with all the settings just as I left them. So far so good but then...
4) I create a new midi track and assign the Aria Player as its instrument. No prob this far but as soon as I play a note on the keyboard, all Pan controls get centered and all volume sliders maximize.

Even further, when the Aria Player gets engaged to a track, if you slide the volume down, it goes back up as soon as you release it like if it was spring loaded :-(

I hope you can help me out !

Thanks in advance :-)

G

Gamma
11-15-2011, 11:55 PM
Hey,

I see a lot of views but no responses so this must be a pretty strange situation.

Garritan and n-track (my sequencer) support people helped me out so I'm posting the solution just in case some one else runs into this:

The midi track is sending and over riding the volume and pan slider values to the Aria Player in GPO4.

If any one needs further info, just ask.

Cheers !

G